Hello,
I'm struggling getting a Drewtronics s5000LED probe working on a ESS/MB3. I can get the probe to trigger in Mach4 but the probe LED does not illuminate, or I can get the probe LED to illuminate, but not trigger in Mach4. When I get the probe to trigger in Mach4, I think I have the probe wired in backwards so the LED is essentially out of the circuit.
I think I am in need of a pull up resistor to help get Mach to trigger as well as light up the LED, but I don't know how to wire one into the MB3 inputs.
Any help would be appreciated.
Lynn